| ServoFoxx
gearboxes from Tandler offer the ultimate in motion control. With ground and matched
set gearing, a
revolutionary integrated bellows coupling for motor connection,
more ratios than any other manufacturer, maximum
performance is assured for
servo applications. The ServoFoxx range provides a flexible system offering any
combination
of ratio with input and output options you require. Thanks to
the incorporation of interchangeable flange plates and a two
part coupling,
the ServoFoxx range is compatible with all motors. |
Low
Backlash - Two levels of backlash optimize and enhance positioning accuracy.
Revolutionary Motor Mount - A flexible motor connection eliminates
misalignment and gear deflection.
Corrosion Resistant - QPQ Nitriding
process provides protection against high moisture environments.
Cast Iron
Housing - Provides superior torsional rigidity over aluminum housings.
More Ratios - Any ratio using combinations of 3:1 to 10:1 are possible.
|
The ServoFoxx inline gearbox offers the ultimate
in motion control.
With ground and matched set gearing, a revolutionary
integrated bellows coupling and motor mount, more ratios available than any other
manufacturer, maximum performance is assured for servo applications.
Maximum
torque up to 2000Nm
4 Standard sizes, single stage with ratios 3:1 to 10:1
2
stage up to 100:1 and 3 stage up to 1000:1.
All ratios can be obtained by
combining ratios between 3 and 10:1 are available
Backlash 5-6 arc minutes
Reduced backlash down to 2 arc minutes.
|
|
| | 
The
FS range enables a servo motor to be mounted directly to a high precision spiral
bevel gearbox. It opens the user to the entire range of Tandler bevel gearbox
designs including hollow shaft, auxiliary output shafts, reinforced shafts and
switching versions.
Maximum torque up to 700Nm
5 Standard sizes with
ratios up to 6:1
Standard backlash 4-5 arc minutes
Reduced backlash down
to 1,5 arc minutes
This Tandler right angle bevel gearbox, designed for
servo applications, incorporates a metal bellows coupling in the motor flange
to eliminate bearing load and seperate the motor bearings from the pinion bearings.
It also opens the user to the entire range of Tandler bevel gearbox
designs including auxiliary outputs shafts, reinforces through shaft and switching
capabilities for example. |
|
| | 
This Tandler right angle planetary bevel gearbox
is one of the most versatile designs on the market. The planetary input can have
up to 3 stages, which in combination with the spiral bevel ratio, allows ratios
up to 6000:1 to be offered. The spiral bevel output stage again opens the user
up to the full range of Tandler spiral bevel gear options.
Maximum torque
up to 1400Nm
9 Standard sizes with ratios up to 6000:1
Standard backlash
7-8 arc minutes
Reduced backlash down to 3 arc minutes
The bevel
section of this gearbox can be configured in any spiral bevel configuration Tandler
offers. the result is an unmatched design flexibility, including auxiliary output
shafts, a hollow output shaft, engage/disengage and reversing capabilities to
name a few.
|
|
| | 
The
SKP-FS range has a spiral bevel input stage and a planetary output, allowing greater
output torques than the PSK2-FS, but with limitations on input speeds.
Maximum
torques up to 1700Nm
4 Standard sizes with ratios up to 54:1
Standard
backlash 7-8 arc minutes
Reduced backlash down to 3 arc minutes
This allows for greater output torques, but has lower input speed constraints. |
|
| 
| |
