ServoFoxx PL2 FS
The ServoFoxx inline gearbox offers the ultimate in motion control.
With ground and matched set gearing, a revolutionary integrated bellows coupling and motor mount, more ratios available than any other manufacturer, maximum performance is assured for servo applications.
Maximum torque up to 2000Nm
4 Standard sizes, single stage with ratios 3:1 to 10:1
2 stage up to 100:1 and 3 stage up to 1000:1
All ratios can be obtained by combining ratios between 3 and 10:1 are available
Backlash 5-6 arc minutes Reduced backlash down to 2 arc minutes
View specification and downloads » ServoFoxx FS
The FS range enables a servo motor to be mounted directly to a high precision spiral bevel gearbox. It opens the user to the entire range of Tandler bevel gearbox designs including hollow shaft, auxiliary output shafts, reinforced shafts and switching versions.
Maximum torque up to 700Nm
5 Standard sizes with ratios up to 6:1
Standard backlash 4-5 arc minutes
Reduced backlash down to 1,5 arc minutes
This Tandler right angle bevel gearbox, designed for servo applications, incorporates a metal bellows coupling in the motor flange to eliminate bearing load and separate the motor bearings from the pinion bearings.
It also opens the user to the entire range of Tandler bevel gearbox designs including auxiliary outputs shafts, reinforces through shaft and switching capabilities for example.
View specification and downloads » ServoFoxx PSK 2
This Tandler right angle planetary bevel gearbox is one of the most versatile designs on the market. The planetary input can have up to 3 stages, which in combination with the spiral bevel ratio, allows ratios up to 6000:1 to be offered. The spiral bevel output stage again opens the user up to the full range of Tandler spiral bevel gear options.
Maximum torque up to 1400Nm
9 Standard sizes with ratios up to 6000:1
Standard backlash 7-8 arc minutes
Reduced backlash down to 3 arc minutes
The bevel section of this gearbox can be configured in any spiral bevel configuration Tandler offers. the result is an unmatched design flexibility, including auxiliary output shafts, a hollow output shaft, engage/disengage and reversing capabilities to name a few.
View specification and downloads » ServoFoxx SKP F5
The SKP-FS range has a spiral bevel input stage and a planetary output, allowing greater output torques than the PSK2-FS, but with limitations on input speeds.
Maximum torques up to 1700Nm
4 Standard sizes with ratios up to 54:1
Standard backlash 7-8 arc minutes
Reduced backlash down to 3 arc minutes
This allows for greater output torques, but has lower input speed constraints.
View specification and downloads »
